Use your nipper tool to cut a two, 24 inch pieces of beading wire.
String around 7 inches of seed beads on each strand. Then, bring the strands together and string them through a bead cap, an onyx bead, another bead cap, 3 seed beads and a final onyx bead. Then string them through your pendant and repeat on the other side.
On each end, string both strands together through a crimp bead, around one end of your toggle and then back through your crimp bead and the first few seed beads. Pull it tightly, crimp the crimp bead and then trim the excess wire with your nipper tool.
Use the round part of your designer crimper tool to place a crimp cover over each of your crimp beads. Enjoy!
Materials and Tools Needed:
Silver Plate Flower Pendant, 5 Petals, 40mm (1)
Miyuki 6-3205, Magic Emerald Marine Lined Crystal (2)
Onyx Round Bead, 12mm (4)
Silver Plate Looped Bead Cap, 12mm (4)
Silver Plate Heart Toggle with Lines, 13mm (1)
Crimp Beads, Bag of 50, 2 x 2mm (1)
Beadalon 49-strand Wire, 30 ft., .015 (1)
Nipper Tool (1)
Beadalon Designer Bead Crimper (1)
Sterling Silver Open Bead Crimp Cover, 3.2 mm, Bag of 10 (1)