0 Item(s) / Total: $0

Autumn Queen Necklace Project

Part Number:PROJ-04267
Autumn Queen Necklace Project

About This Project

This necklace seems a bit "dainty" until you put it on.



Author Susie Henderson
Susie Henderson
Auntie's Beads Co-founder & Jewelry Designer


Step 1. Cut 3 strips of artistic wire, about 8" each in length. Tape the 3 together at one end.

Step 2. On the first strand, add 14 crystals. The middle strand add 15 crystals. The bottom strand add 16 crystals.

Step 3. Pull the 3 strands together tightly, pulling the top one up shorter than the others. Pull the 3 wires through the link. With fingers, wrap the wire tightly through the link. Repeat on other side.

Step 4. Cut 2 pieces of chain, each 14" in length.

Step 5. Find the middle of the chain and add jump ring. Attach jump ring to filligree link.

Step 6. Open jump ring and put both ends of chain into jump ring. Add clasp and repeat on other side.

Materials and Tools Needed:

Swarovski Crystal, 4mm Bicone, Bag of 48, Autumn Mix
Antique Silver Plate Fancy Square Filigree Finding, 16mm
Artistic Silver Plate Wire Spool, 26 gauge, Non-Tarnish Silver
Gunmetal Curb Chain By The Foot, 2.8mm
Gunmetal Plate Lobster Clasp, 10mm
Gunmetal Plate Jump Rings, Open, Bag of 10, 5mm, 20 Gauge

Customer Reviews

5 Stars
crystal play
The necklace can be used with a variety of different colored crystals. You can make one for every season. Love the neck length too.
Did you find this helpful? 
Reviewed by:  from Roswell, NM. on 2/23/2014
5/5

Materials and Supplies Used in This Project:

Beadalon 49-strand Wire, 30 ft., .018
Average Rating15 Review(s)
Sterling Silver Crimp Beads, 2 x 2mm, 50pc
Average Rating25 Review(s)
Classic Nipper Tool
Average Rating26 Review(s)
 
 
 
Back to Top